Highest quality direct from factory
Need help ? 020 3151 3120
171,84 £ tax incl.
Arcapoxy Deco is a solvent free, non-toxic epoxy paint, composed of a 2-pack epoxy wall and floor coating.
Excellent coverage rate 140 sqm for one coat (25kg kit), extremely durable.
Excellent resistance to abrasion, domestic traffic and wear, dries to a tough durable gloss finish resistant to water and water vapour, oils, mild acids and alkalis. For living room, kitchen, basement, loft
Warning: Last items in stock!
Availability date:
ARCAPOXY Deco EPOXY PAINT applies easily to both vertical and horizontal surfaces, indoor and outdoor (Exterior: attention all epoxy paints with UVS can fade slightly), to provide a decorative durable coating on walls and floors in areas subject to domestic foot traffic.
Arcapoxy Deco EPOXY PAINT can be applied as a protective coating over concrete in:
Arcapoxy Deco EPOXY PAINT has excellent adhesion to a wide variety of surfaces: cement, mortar, brick, stone, wood, metal ...
For garage, workshop, small shop floors coatings prefer: ARCAPOXY GARAGE
For factory,public parking, warehouse, stockroom, laboratory, hospital floors coating prefer: ARCAPOXY HEAVY TRAFFIC
* Note: The displayed colour will depend on your monitor and browser and certain colours cannot be shown adequately. To visualize the actual colour, ask us for our colour card.
1st coat = 0.2 kg per sqm (m²) / 2nd coat= 0.15 kg per sqm (m²)
Total of 0.35kg per sqm (m²) for 2 coats
For 5kg kit (4.25kg Part A Resin + 0.75Kg Part B Hardener):
Cover up to 28 sqm for one coat,
Cover up to 14 sqm for two coats
For 25kg kit (21.25kg Part A Resin + 3.75Kg Part B Hardener):
Cover up to 140 sqm for one coat,
Coover up to 70 sqm for two coats
* In order to get an high performance coating system that will last at least 5 years please carefully respect datasheet instructions
Arcapoxy Deco is a solvent free, non-toxic epoxy paint, composed of a 2-pack epoxy wall and floor coating.
Excellent coverage rate 140 sqm for one coat (25kg kit), extremely durable.
Excellent resistance to abrasion, domestic traffic and wear, ARCAPOXY DECO dries to a tough durable gloss finish resistant to water and water vapour, oils, mild acids and alkalis. For living room, kitchen, basement, loft
Application temperature: between 10° and 25° C
Relative humidity maximum 80%
The temperature must be 3°C superior to the dew point
CONCRETE:
Must be 28 days old and free of all laitance. Free water content must be < 4% of the dry mass. Clean with an acid solution to wash off all stains and neutralize the alkalinity of the substrate. Rinse thoroughly leaving no soap or cleaning material suds or residue on the surface. Vacuum the surface once dry.
Note: Very smooth concrete must be cleaned with a hydrochloric acid diluted by 10% to guarantee the penetration of the epoxy paint. Rinse thoroughly after treating and let dry.
TILE:
Degrease, sand lightly in order to give it a texture and open the pores (60 grit sandpaper), removing all loose particles, dust well and repairing any non-adhesive zones before application.
METAL:
Degrease and sand blast ferrous metal surfaces.
WOOD:
Degrease and dust well, removing all loose particles and repairing any non-adhesive zones before application.
ANTI-SLIP:
To render an anti-slipery surface apply 500gr per sqm of silica on the first epoxy paint coat, then brush or vacuum all non adherent silica and then apply the second epoxy paint coat.
Pour the hardener (Part B) steadily into the resin (Part A) and thoroughly mix for 2-3 minutes, preferably by slow speed drill with a paddle attachment until an uniform colour is achieved.
(Never pour directly without mixing, otherwise smoke can appear and the product may be damaged)
You can mix the entire amount or only a part of it depending of how much you need. Remember to always respect/use the ratio: 1 hardener weight to 5.67 resin weigth - 15% hardener to 85% of resin
Apply with a brush, roller, smoothing trowel.
Apply two coats of ARCAPOXY Deco EPOXY PAINT directly on a completely dry surface. At 20°C allow 24 hours to dry between coats.
Store in dry, cool and frost free conditions. Shelf life is 12 months inunopened original packaging.
Dust free: 4 hours at 20°C, 12 hours at 10°C
Dry to touch: 8 hours at 20°C, 18 hours at 10°C
Recoverable: 18 hours
Allow to cure for a minimum of 24 hours prior to light foot traffic access, 5 days to heavy foot traffic access and 7 days cure at 20°C prior to exposure to chemicals. Lower temperatures will extend the curing time.
Promptly clean hand and all tools with an epoxy thinner.
1st coat = 0.2 kg per sqm (m²) / 2nd coat= 0.15 kg per sqm (m²)
Total of 0.35kg per sqm (m²) for 2 coats
5 kg kit : cover up to 14 sqm (m²) for 2 coats
Composed of a 4.25kg resin (part A) and a 0.75kg hardener (part B)
25 kg kit: cover up to 70 sqm (m²) for 2 coats
Composed of a 21.25kg resin (part A) and a 3.75kg hardener (part B)
1st coat = 0.2 kg per sqm (m²) / 2nd coat= 0.15 kg per sqm (m²)
Total of 0.35kg per sqm (m²) for 2 coats
5 kg kit : cover up to 14 sqm (m²) for 2 coats
Composed of a 4.25kg resin (part A) and a 0.75kg hardener (part B)
25 kg kit: cover up to 70 sqm (m²) for 2 coats
Composed of a 21.25kg resin (part A) and a 3.75kg hardener (part B)
Quick Delivery
Departure from French Manufacturer within 24 hours (excepted for custom colours) Delivery time within 5-7 days
Secure Payment
All your transactions are 100% secure and safe
Direct Price from our Factory
No intermediary, cheapest prices for highest quality.
Need Help?
We are available to answer your questions on:
020 3151 3120 or by mail: contact@arcane-industries.co.uk